Residential
Strip to the deck so the sheathing can actually be inspected and re-fastened, then new underlayment, new flashing and new covering. On an older house this is the only honest approach.
Roofing in Fort Pierce · St. Lucie County Older roof assemblies beside a working inlet
Fort Pierce is the oldest city on this stretch of the Treasure Coast — a real downtown, a working waterfront at the inlet, older neighborhood housing and barrier-island frontage beyond it. Roofs range from decades-old shingle to commercial low-slope. Perkins Roofing serves it from the Jupiter office in St. Lucie County.
-
01
Jupiter office Served from Perkins’ north branch
-
02
Older assemblies Deck and flashing conditions deserve written allowances
-
03
Inlet exposure Open wind and salt increase coastal demands
-
04
Mixed roof stock Neighborhood shingle through commercial low-slope
Satellite map
Fort Pierce in St. Lucie CountyInteractive satellite map locating Fort Pierce, with the verified Census place boundary and Florida Building Code wind-speed contour lines overlaid.Loads an interactive satellite map when selected.Verified data layer Open the authoritative boundaries and overlays
Fort Pierce
Design wind speed contour · 150 / 160 mph · FBC Fig. 1609.3(1)
- Expect the permit from
- City of Fort Pierce building department
- High Velocity Hurricane Zone
- No. The code defines the HVHZ as Broward and Miami-Dade counties only, and St. Lucie County is not one of them.
- Design wind speed contours crossing St. Lucie County
- 150 mph 160 mph Ultimate design wind speed, Risk Category II, from Florida Building Code (2023) Figure 1609.3(1). The governing value for a specific address is set by the design professional and confirmed by the building official.
Roofing in Fort Pierce · St. Lucie County · complete briefing
Fort Pierce roofing and inlet-exposure guide
The building stock
Older roofs, and older decisions under them
Fort Pierce has been here long enough that most of its houses are not on their first roof, or their second. That is the defining condition of roofing work in the city: the covering you can see says very little about the assembly beneath it. Previous re-roofs, added layers, re-used flashing, patched decking and forty years of penetrations are all normal, and none of them show up from the street.
Geography splits the city as well. Downtown and the waterfront near the inlet take open exposure and salt; the neighborhoods spreading west are sheltered by comparison. The same roof age can therefore be in two quite different conditions on either side of town, and the difference usually shows in the metal first.
One piece of good news for owners here: St. Lucie has the lowest average homeowners premium of the six counties we work in — $3,491 including wind coverage in the Florida Office of Insurance Regulation’s July 2026 stability report, against $5,899 next door in Martin and $5,975 in Miami-Dade. It is also the fastest-growing, up 22.2 per cent since 2020 on Census Bureau Vintage 2025 estimates, which is why so much of the roofing work here is older stock being brought up to date rather than new construction.
For a single failure, start with roof repair. For a roof at the end of its life, see residential roofing.
What we do here
Roof work in Fort Pierce
Flat
Modified bitumen and single-ply membrane over commercial and mixed-use buildings, where drains, terminations and ponding decide how long the roof lasts.
Metal
Standing seam on waterfront and island properties, with concealed fasteners and corrosion-resistant hardware for the exposure near the inlet.
Permitting authority and design wind speed
Fort Pierce within St. Lucie County
Which department to expect a roofing permit from, and the ultimate design wind speed contours the Florida Building Code draws across St. Lucie County. Hover or tap a contour to read its value.
Satellite map
Fort Pierce in St. Lucie CountyInteractive satellite map locating Fort Pierce, with the verified Census place boundary and Florida Building Code wind-speed contour lines overlaid.Loads an interactive satellite map when selected.Verified data layer Open the authoritative boundaries and overlays
Fort Pierce
Design wind speed contour · 150 / 160 mph · FBC Fig. 1609.3(1)
- Expect the permit from
- City of Fort Pierce building department
- High Velocity Hurricane Zone
- No. The code defines the HVHZ as Broward and Miami-Dade counties only, and St. Lucie County is not one of them.
- Design wind speed contours crossing St. Lucie County
- 150 mph 160 mph Ultimate design wind speed, Risk Category II, from Florida Building Code (2023) Figure 1609.3(1). The governing value for a specific address is set by the design professional and confirmed by the building official.
How we cover it
Served from the Jupiter office
Fort Pierce is the northern end of the Perkins Roofing service area and is covered from the Jupiter office, one of two Florida offices. There is no Fort Pierce address and no Fort Pierce phone number. See the Jupiter office page or the St. Lucie County service area.
Questions
Fort Pierce roofing FAQ
What is different about roofing an older Fort Pierce house?
What is under the covering. Older homes here have been re-roofed more than once, sometimes with layers added rather than removed, and the deck, the framing and the original flashing details are unknowns until the roof is open. A responsible estimate says in writing what happens if rotten sheathing is found, rather than pretending it will not be.
Does the inlet make the exposure worse?
Near the inlet and out on the island, properties get open wind fetch and salt-laden air with nothing in the way. Salt reaches the metal in a roof first — fasteners, flashings, drip edge, valley metal — so hardware specification matters more in those blocks than it does a few miles inland to the west.
Is Fort Pierce in the High Velocity Hurricane Zone?
No. The HVHZ is a county-boundary designation in the code and consists of Broward and Miami-Dade only. Fort Pierce is in St. Lucie County, where the requirements come from the Florida Building Code as adopted and administered locally — and locally matters, because the city permits separately from the county. St. Lucie County’s Building and Code Regulation Division at 2300 Virginia Avenue in Fort Pierce covers unincorporated county only; Fort Pierce, Port St. Lucie and St. Lucie Village each permit their own. Confirm which one your address falls under before anything is filed.
Do you work on commercial buildings downtown?
Yes. Low-slope commercial and mixed-use roofs are a large part of the work: modified bitumen and single-ply membrane, coatings where a roof is a genuine candidate for restoration, and phased replacement over buildings that have to stay open while the work runs.
Is there a Perkins Roofing office in Fort Pierce?
No. Perkins Roofing has two Florida offices, Miami and Jupiter. Fort Pierce and the rest of St. Lucie County are served from the Jupiter office.
Fort Pierce is one city in the South Florida service area.
Free estimate
Find out what is under the covering.
On an older Fort Pierce roof, that is the only question that matters.
Page updated